The basic components of stainless steel press-fittings is special shaped pipe joints with O-shape seal set 

in the U-shape on the top. When assembling ,insert stainless steel water pipe to the fittings,and seal it with

special sealing tool.The part being sealed will be pessed into hexogan,so that to form enough connection

intensity,meanwhile ,because of the compressive deformation of the seal,the good seal effected.

 

 

Prominent characteristic of products: Good quality stainless steel selection and advanced joint technics.
High anti-corrosion function : more than 50 years of useful life.
Good sanitary capability: During useful years , satisfy drinking water criterion of domestic,Japan,Europe and

other international ones.
High shock resistance function: The intensity of water pipe is 2 times of zinc-plated pipe,3 times of copper

pipe,joint intensity is especially high.
Low themoconductivity: 1/25 of copper,1/4 of steel pipe,slow in heat expansion and cold shrink.
Save materials: Since adoption of thin wall style,the weight is only 1/3 of zinc-plated pipe, a lot of materials

are saved, the products‘ weight is lighten,esp.applicable for accessory pipes in super high building.
Easy to operate,short time operation: This is connected without screwing,no complicated screw thread-making

work,no welding processing,no oil & welding pollution while cutting or jointing,use special tool to seal &

press,the piping will be finished instantly.
Fine appearance: both newly-installed and long time used products can match the new decorated surroundings.
Smooth inner wall of joint: The diameter of joint and pipe are the same,less water resistance.

 

 

Material: use austenitic stainless steel 0Cr18Ni9(SUS304)；while adopt austenitic stainless steel 0Cr17Ni12Mo2

(SUS316) and 00Cr17Ni14Mo2(SUS316L) in somewhere require high corrosion-proof function.
Seal: O-shaped seal ring is made of Butyl rubber,hot water resistance,ageing resistance,additives resistance,and

used for drinking water.
Nominal diameter:DN5~100mm.
Working pressure:maximum 1.6Mpa.
Working temperature:-20~110℃.
Connection method: Press connection.

 

 

Don’t stab O-shaped seal ring in pipe.
The pipe should be surely inserted into the correct position marked with linedraw.
Don’t forget pressing work.